Filter
Top Products
SKU 94101 For technical questions, please call 1-800-444-3353. Page 4
Caution: Make sure the pipe end and threads of the die are suffi-
ciently oiled at all times. Otherwise, die life will be shortened and
the threads will be rough.
3. While applying pressure to the end of the pipe, begin rotating the Handle around the pipe
to engage the die to the pipe end. Continue this operation until the desired thread length
is achieved.
4. To disengage the Ratchet Holder after threading is complete, follow steps discussed in #7
on prior page to reverse the direction, and then rotate the Handle until the die is disen-
gaged from the pipe end.
5. When sliding the pipe out of the Ratchet Holder, be careful not to damage newly cut
threads.
Maintenance
1. Clean the Pipe Threading tool after each use. Clean dies after each use. Check for bro-
ken teeth or pipe material between teeth.
2. When not in use, store all parts in the case, and store the case in a dry location.
Operation (continued)