Filter
Top Products
Page 9SKU 95801
For technical questions, please call 1-800-444-3353.
OPERATION INSTRUCTIONS
With the proper tool attached to the Air Hammer, attach your air supply to the Air
Inlet (7) at the base on the Housing (1). Turn on the air supply. Carefully place the
tool against the surface of the project you are working with. Make sure the project
is in a vise or attached to something that holds it securely so it cannot be moved
out of position.
Set the Air Regulator (11) located at the base of the Housing (1). Air pressure
should not exceed 90 PSI. Test the action of the Air Hammer and adjust the
Air Regulator (11) as necessary.
Use a light touch on the Trigger (8). Never force the Air Hammer against the surface
you are working with. Easy, light pressure works best.
WARNING: If the Air Hammer is being used as a Scaler, use a ANSI-approved full
face shield and not just safety goggles to protect against Needles that may snap
off and could possibly cause personal injury.
INSPECTION, MAINTENANCE, AND CLEANING
WARNING! Make sure air compressor is unplugged and that the Air Hammer
is disconnected from its Air Supply before performing any inspection, maintenance,
or cleaning procedures.
BEFORE EACH USE, inspect the general condition of this tool. Check for loose
screws, misalignment or binding of moving parts, cracked or broken parts, damaged
air hoses, and any other condition that may affect its safe operation. If abnormal
noise or vibration occurs, have the problem corrected before further use. Do not
use damaged equipment.
MAINTENANCE CHART
Maintenance Type
Before
Use
After
Use
Weekly Monthly
Every 6
Months
Yearly
Inspect the Air Hammer for
damage
(see #2, above)
X X
Wipe off with clean, moist
cloth
X X
TROUBLESHOOTING
Problem Possible Causes Probable Solutions
Air Hammer will not
start
Air supply not connected.
Air Regulator (11) not turned up.
1.
2.
Check air connection.
Turn up Air Regulator (11).
1.
2.
1.
2.
3.
1.
2.