Filter
Top Products
Page 7SKU 96755 For technical questions, please call 1-800-444-3353.
MAINTENANCE AND SERVICING
Cleaning and Removing the Staple Channel
Push the Retaining Clip at the front of the Staple Gun forward to release the
Staple Channel. Pull the two tabs (located midpoint on the bottom of the Staple
Gun) toward the back of the Staple Gun.
The Staple Channel is now free of the Staple Gun and can be cleared of any
jammed fasteners and debris.
Cleaning, maintenance, and lubrication
BEFORE EACH USE, inspect the general condition of this product. Check for
loose screws, cracked or broken parts and any other condition that may affect its
safe operation.
Remove dirt and debris from the Staple Gun using a clean, soft cloth. Do not
use ammable corrosive or abrasive solvents to clean the Staple Gun.
TROUBLESHOOTING
Problem Possible Causes Probable Solutions
Staple Gun does not staple Staples not loaded
correctly.
Magazine Unit not fully
and properly inserted into
Staple Gun.
Lever not pulled
completely up and then
fully pressed down.
1.
2.
3.
Verify that staples are loaded into
the Magazine Unit at and with
prongs facing upward.
Check that Magazine Unit is fully
inserted.
1.
2.
Stapler jams during operation Staples jammed in
channel.
1. Pull out the Staple Channel.
Remove jammed fasteners
from the channel. You may
need to use long-nosed pli-
ers (not included).
Make certain that you are
using correct size fasteners.
Replace Staple Channel.
1.
2.
3.
4.
1.
2.
1.
2.