Filter
Top Products
SKU 98089 For technical questions, please call 1-800-444-3353 PAGE 2
PRODUCT SPECIFICATIONS
Required Saw Blade Type 14” Diameter (Not Included)
7/64” to 1/4” Thickness
Composite Abrasive or Diamond Abrasive
Rated at a Minimum 4700 RPM
1” Diameter Spindle Hole
Maximum Saw Blade Speed 4700 RPM
Saw Blade Rotation Clockwise
Maximum Cutting Depth 4-1/2”
Drive Type Belt Driven
Belt Type 10X855 Li (3/4” Width)
Spindle Diameter 1” Diameter
Noise Level 110 dBA @ 3 Feet
Engine Specications 3.8 HP / Recoil Start / Air Cooled
Engine Idle Speed: 3000 RPM
64cc Displacement / 49mm Cylinder Bore / Single Cylinder / 34mm Piston Stroke
Fuel Mix: Unleaded Gasoline with Octane Rating of 91 / Two Stroke Engine Oil / Ratio 50:1
Fuel Tank Capacity: 0.4 Gallons
Ignition Type: Electronically Controlled Magneto
Spark Plug Type: NHSP LD L9T, or Bosch WSR 6F or NGK BPMR 7A; M14 x 1.25 Thread
Engine Approvals: 2003 U.S. EPA
Emission Control: EM / TWC
Optional Water Feed
Attachment (not included)
Available from Harbor Freight Tools, SKU 95456 (WARNING: DO NOT USE A DIAMOND BLADE
ON THIS SAW WITHOUT USING THE WATER FEED ATTACHMENT!)
The Emission Control System for this Cut Off Saw is warranted for standards set by the U.S.
Environmental Protection Agency. For warranty information, refer to the back two pages of this manual.
SAVE THIS MANUAL
You will need this manual for the safety warnings and precautions, assembly,
operating, inspection, maintenance and cleaning procedures, parts list and assembly
diagram. Keep your invoice with this manual. Write the invoice number on the inside
of the front cover. Keep this manual and invoice in a safe and dry place for future refer-
ence.
GENERAL SAFETY RULES AND PRECAUTIONS
WARNING!
READ AND UNDERSTAND ALL INSTRUCTIONS
Failure to follow all instructions listed below may result in
electric shock, re, and/or serious injury.
SAVE THESE INSTRUCTIONS
WORK AREA
Keep your work area clean and well lit.1. Cluttered benches and dark areas invite
accidents.
Do not operate power tools in explosive atmospheres, such as in the pres-2.
ence of ammable liquids, gases, or dust. Power tools create sparks which
may ignite the dust or fumes.
Keep bystanders, children, and visitors away while operating a power tool. 3.
Distractions can cause you to lose control. Provide barriers or shields as needed.