Harbor Freight Tools 98896 Drill User Manual


 
SKU 98896 For technical questions, please call 1-800-444-3353. Page 8
FUNCTIONAL DESCRIPTION
Specications
Air Pressure Range 90 PSI
Maximum Air Pressure 90 PSI
Air Inlet 1/4" -18 NPT
Maximum Speed* 700 RPM
Air Consumption 5 CFM @ 90 PSI
Arbor/Chuck Capacity 1/16 - 1/2"
* Maximum speed at stated maximum air pressure.
Excess air pressure is hazardous and may cause the
tool to exceed stated maximum speed.
Components and Controls
Fig. 1
Trigger
Forward/Reverse
Lever
1. Reversible feature controled by the
Forward/Reverse lever next to the
power trigger. (See Fig. 1.) Move
switch up toward “F” for forward and
down toward “R” for reverse
INITIAL TOOL SET UP/
ASSEMBLY
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Unpacking
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown throughout the manual as soon as
possible.
This air tool may be shipped with a
protective plug covering the air inlet.
Remove this plug before set up.
Air Supply
TO PREVENT
EXPLOSION:
Use only clean, dry, regulated,
compressed air to power this
tool. Do not use oxygen,
carbon dioxide, combustible
gases, or any other bottled
gas as a power source for this
tool.
Fig. 2
1. Incorporate an in-line oiler, shut-off
valve, regulator with pressure gauge,