Filter
Top Products
SKU 99925 For technical questions, please call 1-800-444-3353. Page 9
ing the air output gauge to set the
right pressure range.
The Air Compressor will cycle up to 9.
125 PSI before shutting off. It will
start to build pressure again when the
PSI of the Compressor drops to 90
PSI.
If the Compressor becomes too hot 10.
the circuit breaker will trip and it will
shut off. If this happens;
move the Power Switch to the OFF a.
position;
unplug the Air Compressor;b.
wait until the Compressor cools c.
down;
plugging the Air Compressor back in d.
will reset the circuit breaker;
turn Power Switch back to the ON e.
position and resume operation.
After the job is complete, move the 11.
Power Switch to the OFF position.
Pull down on the Safety Valve by 12.
Tank Pressure Gauge to release
pressure. Squeeze the Trigger of the
air tool to release pressure from the
line.
Turn the Drain Valve (29), at the bot-13.
tom of the Tank, two turns to release
any built-up moisture. Close the
valve after moisture has drained out.
Do not remove the Drain Valve.
Drain Valve
Disconnect the air hose and tool.14.
To prevent accidents, disconnect its 15.
power supply after use. Clean, then
store the tool indoors out of children’s
reach.
REV 08j