Filter
Top Products
SKU 46388 Page 7
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM
IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER
NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO
THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE
PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE
PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY
STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN
BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER
ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS
OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
5. Check to be sure all attachments are secure before turning on the tool. Adjust
the Wheel Guard so that it provides a shield between you (the user) and the
material you are working on. The Wheel Guard must be in place at all
times when using the Angle Grinder.
6. Grip the Handle with your left hand and the Housing [25] with your right.
Depress the Trigger [31] with your right hand to turn the tool on. Allow the
motor to reach its full speed before grinding. Make sure the Wheel is
rotating evenly and all parts appear to be working properly. Always maintain
a firm grip with both hands when operating this tool.
7. To begin cutting or grinding, approach the material at an angle between 15
and 30 degrees to the Wheel. Maintain that angle until you are finished
cutting/grinding. Do not force the Wheel or apply too much pressure. If the
Wheel slows down as you work with your material, you are applying too
much pressure.
8. Once you have turned the Grinder off, continue to hold onto the tool with
both hands until the motor stops completely before you set it down.