Filter
Top Products
CD-PULSAR-INST-9-06
- 3 -
BENEFITS
• Protective glow ring (bezel) helps prevent lens breakage and provides an
indication that the light is on if placed face down.
• Bulb mount design allows replacing bulb quickly without tools.
• Quartz halogen bulbs provide brilliant white light and last up to 100 hours.
• Standard 9 foot coil cord minimizes voltage drop for maximum power.
OPTIONS & ACCESSORIES
Part Number Description
CD-DMB-1 Dash mounting clip for mounting the Pulsar & Genesis handheld
light unit
CD-RR-46 Hypalon Rubber Ring For 6" reflector diameter
CD-RR-56 Hypalon Rubber Ring For 7” reflector diameter
CD-H1100W Replacement bulb for CD-PULS500
CD-H2100W Spot replacement bulbs for CD-PULS750
CD-H255W12 Flood replacement bulbs for CD-PULS750
BULB REPLACEMENT
CD-PULS500
1. Remove the rear cap by twisting counter
clockwise.
2. Remove wire lead from bulb, removed
spring clip and pull bulb out of reflector
3. Take new bulb out of box. Handle bulb only
by rear terminal. DO NOT HANDLE
GLASS PORTION OF BULB.
4. Insert new bulb through rear reflector mount
so that bulb flange is seated flush against the
back of the reflector housing. (Bulb will
only fit flush one way).
5. Fasten bulb retainer spring clip in hole and
notch.
6. Re-install wire lead onto back of bulb.
7. Replace rear cap by twisting clockwise.
CD-PULS750
1. Remove the rear cap by twisting counter
clockwise.
2. Grasp bulb mount assembly and withdraw
from head. Separate sections
3. Remove bulb to be replaced. Use cloth. Insert
new bulb and check for proper alignment.
4. Connect bulb mount sections and slide into
head. Note alignment slots.
5. Check alignment in reflector. Two dowel pins
must protrude through reflector for proper
alignment.
6. Replace cap onto head, twist clockwise to
lock.