Havis-Shields F2 Drill User Manual


 
WGI-F1-F2-F3-F4_INST_7-08
3. Notching Plastic:
The window trim for the first drivers’ side window (F1-1) must be cut where the pop out
window latches are located.
Mark the “V” shaped foot print of latch and cut plastic trim. The latches will bolt back
against metal at the original location.
4. Final Touches:
The trim sections at the top and at the rear doors may stick out a little at the top where it
meets the headliner.
Use a #10 x 1 ¼” Sheet metal screw to secure it down at the top of the trim.
Some trim panels between windows may also need sheet metal screws to secure them.
Attach supplied Window Latch cover plates as shown below using #10 x ½” sheet metal
screws as shown below.
NOTE: The headliner will push against the window guards. This may cause the headliner to
buckle slightly. If desired, the headliner can be carefully trimmed (cut) with a razor knife
where it meets the window guard. This will alleviate the buckling headliner.
Window Latch cover plate
Trim (cut) headliner if desired