Filter
Top Products
WGI-F1-F2-F3-F4_INST_7-08
3. Notching Plastic:
• The window trim for the first drivers’ side window (F1-1) must be cut where the pop out
window latches are located.
• Mark the “V” shaped foot print of latch and cut plastic trim. The latches will bolt back
against metal at the original location.
4. Final Touches:
• The trim sections at the top and at the rear doors may stick out a little at the top where it
meets the headliner.
• Use a #10 x 1 ¼” Sheet metal screw to secure it down at the top of the trim.
• Some trim panels between windows may also need sheet metal screws to secure them.
• Attach supplied Window Latch cover plates as shown below using #10 x ½” sheet metal
screws as shown below.
NOTE: The headliner will push against the window guards. This may cause the headliner to
buckle slightly. If desired, the headliner can be carefully trimmed (cut) with a razor knife
where it meets the window guard. This will alleviate the buckling headliner.
Window Latch cover plate
Trim (cut) headliner if desired