Havis-Shields LED Gooseneck Map Light Work Light User Manual


  Open as PDF
of 2
 
H:\Cons\Misc\LED-Map-Light-Inst-8-08.doc
3. Operation:
• Power is supplied through a three-position switch. The center position is “off,” and
the up and down positions provide red or white light.
4. Troubleshooting:
• Use a voltmeter to ensure that the fixture is receiving adequate power. The light
requires nominally 12 VDC for correct operation. Correct any faults found.
• A bad ground connection can cause improper operation. Use a negative wire instead
of connecting power to the vehicle chassis to avoid any ground issues.
• The light will not be able to turn on if polarity is reversed.
TEMPLATE:
∅0.16 (5/32” Drill)
Mounting Holes
∅0.50 (1/2” Drill)
Wireway
1-23/3221/32
Cli
p
Here
Cli
p
Here
To Switch,
Circuit and
LEDs
+12 VDC
Power
1A Fuse
(Recommended)
User-Supplied
Connector
(Optional)
Ground
HOT - RED
COMMON - BLACK
Note:
Fuse, fuse holder, and connector are
not supplied by Havis-Shields.
 previous