Filter
Top Products
16 HP MSA 500 G2 Storage System Maintenance and Service Guide
2. Close the slot latches.
3. Close the controller.
Blower
To remove the component:
WARNING: The blower blades rotate at a high speed.
Avoid touching the rotating blades when removing the blower.
NOTE: The power supply is designed so that removing a blower does
not adversely affect system performance. However, do not remove a
blower until the replacement blower is available.
To replace the blower:
1. Align the guidepost on the blower with the connector on the power supply.
CAUTION: Do not press on the center section of the blower
because this action can damage the blades. Press only on the outer
edge of the blower.
2. Slide the blower into the connector until it locks into place.
3. Be sure the following conditions occur: