Filter
Top Products
NOTE:
More options will be supported in the future. See BC options for further information.
The Apply button applies the option settings in the Select Option box.
Setting a BC option (Swap&Freeze option)
1. In the BC main screen, click Option to display the Select Option box.
Select the option check box. If you do not want to set any option, clear all check boxes in the
Select Option box.
2. Click Apply. You can now perform a BC operation with the specified option.
BC error codes
BC displays error messages when error conditions occur during BC operations. The BC Error window
displays the BC error code and message. To display the Error window, select the failed volume in the
Preset Volume list on the BC main screen (Display tab), right-click, and select Detail. The following table
describes the BC error codes and provides instructions for resolving each error condition.
Table 23 BC error codes
Error
Code
Description Corrective Action
0401
Alockingtime-outwasdetectedduringan
internal processing.
A retry may result in a normal termination. Retry
about five seconds later.
0402
A command (Paircreate, Pairsplit, or Reserve
Volume) could not be completed because it was
not in the SMPL status internally.
A retry may result in a normal termination. Retry
about five seconds later.
0801
The BC feature could not be used.
Ensure that the disk array has the correct
microcode level for BC, the disk array has BC
installed and enabled, and the Command View
XP management station or XP Remote Web
Console has BC installed and enabled.
080B
The request could not be accepted. Retry about one minute later.
0810
The specified command cannot be accepted in
this status. (The command was rejected.)
Check the pair status, and ensure that the pair
status is correct for the command.
0811
The specified command is treated as an NOP. The specified command is treated as an NOP.
(NOP means the command can end without
errors, but executes nothing.)
0812
Thenewpaircouldnotbecreatedbecausea
path group is set.
Disconnect from host, or cancel Continuous
Access XP path.
On the Continuous Access XP main screen,
confirm the specified S-VOL is simplex, specify
the Delete Pair by Force option, and retry the
operation.
0813
The Pairsplit command was issued to a pair in
the PSUS status.
The Pairsplit command cannot be issued
because the pair is already in PSUS status.
0814
ThePaircreatecommandwasissuedtothepair
in the PAIR status.
The Paircreate command cannot be issued
because the pair is already in PAIR status.
0817
A Reserve volume cannot be set because a path
group is set.
Disconnect volume to be reserved from host, or
delete Continuous Access XP path.
Business Copy XP user guide
77