Filter
Top Products
RPM
Obligation signs
Wear eye
protection
Wear a hard
hat
Wear ear
protection
Wear
protective
gloves
Wear
breathing
protection
Symbols
Read the
operating
instructions
before use
Return waste
material for
recycling.
Volts Direct current
Rated speed
under no load
Revolutions
per minute
Revolutions per
minute
Location of identification data on the power tool
The type designation can be found on the type iden-
tification plate and the serial number on the side of
the motor housing. Make a note of this data in your
operating instructions and always refer to it when
making an enquiry to your Hilti representative or
service department.
Type:
Generation: 01
Serial no.:
2. Description
2.1 Use of the product as directed
The SID 14-A, SIW 14-A, SID 18-A and SIW 18-A are hand-held cordless impact screwdrivers/wrenches. They
are designed for driving and removing screws in wood, metal, masonry and concrete and for tightening and
releasing nuts and bolts.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
Do not use the battery as a power source for other unspecified appliances.
Modification of the power tool or tampering with its parts is not permissible.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
The power tool should not be used for applications that require a precise torque. For applications that require
a precise torque or where only a special limited torque is permitted, there is a risk of over-tightening and
damage to the screw or workpiece. For these types of application, use a tool with a predefined torque setting
to prevent over-tightening.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The
power tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or
when used not as directed.
The working environment may be as follows: construction site, workshop, renovation, conversion or new
construction.
en
2