Filter
Top Products
307-830 3
WARNING
INJECTION HAZARD
Spray
from the gun, leaks or ruptured components can inject fluid into your body and cause extremely
serious injury, including the need for amputation. Fluid splashed in the eyes or on the skin can also
cause serious injury
.
D
Fluid injected into the skin is a serious injury
. The injury may look like just a cut, but it is a serious
injury
. Get immediate medical attention.
D
Do not point the gun at anyone or at any part of the body
.
D
Do not put your hand or fingers over the spray tip.
D
Do not stop or deflect leaks with your hand, body
, glove or rag.
D
Do not “blow back” fluid; this is not an air spray system.
D
Always have the tip guard and the trigger guard on the gun when spraying.
D
Check the gun dif
fuser operation weekly
. Refer to the gun manual.
D
Be sure the gun trigger safety operates before spraying.
D
Lock the gun trigger safety when you stop spraying.
D
Follow the
Pressure Relief Procedure
on page 1
1 if the spray tip clogs and before cleaning,
checking or servicing the equipment.
D T
ighten all fluid connections before operating the equipment.
D
Check the hoses, tubes, and couplings daily
. Replace worn or damaged parts immediately
. Do not
repair high pressure couplings; you must replace the entire hose.
D
Fluid hoses must have spring guards on both ends, to help protect them from rupture caused by
kinks or bends near the couplings.
TOXIC FLUID HAZARD
Hazardous
fluid or toxic fumes can cause serious injury or death if splashed in the eyes or on the skin,
inhaled, or swallowed.
D
Know the specific hazards of the fluid you are using.
D
Store hazardous fluid in an approved container
. Dispose of hazardous fluid according to all local,
state and national guidelines.
D
Always wear protective eyewear
, gloves, clothing and respirator as recommended by the fluid and
solvent manufacturer
.
MOVING
P
ARTS HAZARD
Moving
parts can pinch or amputate your fingers.
D
Keep clear of all moving parts when starting or operating the pump.
D
Before servicing the equipment, follow the
Pressure Relief Procedure
on page 1
1 to prevent the
equipment from starting unexpectedly
.