Filter
Top Products
14
STANDARD ACCESSORIES
Standard accessories are subject to change without notice.
C6DD
1 Saw Blade (mounted on tool) ................................................................................ 1
2 Box Wrench ................................................................................................................ 1
3 Guide ............................................................................................................................ 1
4 Wing-bolt ..................................................................................................................... 1
5 Charger (UC24YFA) .................................................................................................... 1
6 Plastic case.................................................................................................................. 1
OPTIONAL ACCESSORIES (sold separately)
1. Battery (EB1814, EB18B, EB1820, EB1830H)
2. Saw Blade
Use......Cutting various types of wood.
External Diam Hole Diam. No. of Teeth
165 mm 16 mm 16 pieces
165 mm 20 mm 16 pieces
165 mm 30 mm 16 pieces
3. Washer (A) .... for 16 mm (Hole dia .of saw blade)
.... for 20 mm (Hole dia. of saw blade)
.... for 30 mm (Hole dia. of saw blade)
4. Dust Collector Set (D)
Connect the suction hose to collect saw dust with
the vacuum cleaner (see Fig. 30).
Optional accessories are subject to charge without notice.
APPLICATION
Cutting various types of wood.
BATTERY REMOVAL/INSTALLATION
1. Battery removal
Hold the handle tightly and push the battery latches
to remove the battery (see Fig. 8,9).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 9).
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger’s power cord to a receptacle.
When the power cord is connected, the charger’s
pilot lamp will blink in red. (At 1-second intervals).
2. Insert the battery into the charger.
Firmly insert the battery into the charger till it
contacts the bottom of the charger and checking
the polarities as shown in Fig. 10.
CAUTION
⅜ If the batteries are inserted in the reverse direction,
not only recharging will become impossible, but it
may also cause problems in the charger such as
a deformed recharging terminal.
3. Charging
When inserting a battery in the charger, charging
will commence and the pilot lamp will light
continuously in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (At 1-second intervals.) (See
Table 1)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown
in Table 1, according to the condition of the charger
or the rechargeable battery.
1
6
2
3
5
4