Filter
Top Products
English
23
1. Dismounting the saw blade
(1) Set the cutting volume at maximum, and
place the Circular Saw as shown in
Fig. 18.
(2) Depress the lock lever, lock the spindle,
and remove the hexagonal-head bolt and
washer(B1) with the box wrench.
(3) While holding the safety cover lever to
keep the safety cover fully retracted into
the saw cover, remove the saw blade.
(Fig. 19)
2. Mounting the Saw Blade (Fig. 20)
WARNING:
If the bolt is worked using other tools
than the provided box wrench, excessive
tightening and insufficient tightening
may take place, resulting in injury.
⅜ Take procedures here that are contrary to
the detaching procedures.
NOTE:
ⅷ Thoroughly remove any sawdust which
has accumulated on the spindle, bolt and
washers.
ⅷ To assure proper rotation direction of the
saw blade, the arrow direction on the saw
blade must coincide with the arrow
direction on the saw cover.
ⅷ Using the fingers, tighten the hexagonal-
head bolt retaining the saw blade as much
as possible. Then depress the lock lever,
lock the spindle, and thoroughly tighten
the hexagonal-head bolt.
CAUTION:
After mounting the saw blade, reconfirm
that the lock lever is firmly secured in the
prescribed position.
Fig. 18
Fig. 19
Fig. 20
Box Wrench
Lock Lever
Tighten
Loosen
Safety
Cover Lever
Saw Cover
Hexagonal-Head Bolt
Ring
Washer (B1)
Washer (A1)
Concave
Spindle
Saw Blade