Filter
Top Products
14
English
1. Insert the plug of battery charger into the receptacle.
When the plug of battery charger has been inserted into the receptacle, the charge
status lamp will blink in red. (At 1-second intervals)
WARNING:
Do not use the electrical cord if damaged. Have it repaired
immediately.
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as shown in Fig. 4. Make sure it contacts the
bottom of the battery charger.
Fig. 4
3. Charging
⅜ When the battery is connected to the battery charger, charging will commence and the
pilot lamp will light in red. (See Table 2)
NOTE: If the pilot lamp flikers in red, pull out the plug from the receptacle and check if
the battery is properly mounted.
⅜ When the battery is fully charged, the pilot lamp will bilink in red slowly. (At 1-second
intervals) (See Table 2)
Battery
Charge status lamp (red)
Overheat lamp (green)