Filter
Top Products
English
11
APPLICATIONS
⅜
Cutting metal and stainless steel pipe.
⅜
Cutting various lumber.
⅜
Cutting mild steel and aluminum.
⅜
Cutting synthetic resins, such as phenol resin and
vinyl chloride.
REMOVAL AND INSTALLATION METHOD
OF BATTERY
⅜
How to install the battery.
Align the battery with the groove in tool handle and
slip it into place.
Always insert it all the way until it locks in place with
a little click, If not, it may accidentally fall out of the
tool, causing injury to you or someone around you
(Fig. 3).
⅜
How to remove the battery.
Withdraw battery from the tool handle while
pressing the latch (2 pcs) of the battery (Fig. 3).
ASSEMBLY AND OPERATION
Fig. 3
Latch
Handle
Insert
Battery
Pull out
Push
CHARGING METHOD
NOTE:
Before plugging into the receptacle, make sure the
following points.
⅜
The power source voltage is stated on the
nameplate.
⅜
The cord is not damaged.
WARNING:
Do not charge at voltage higher than indicated on
the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn out.
Battery
Fig. 4
Pilot lamp
1. Insert the plug of battery charger into the receptacle.
WARNING:
Do not use the electrical cord if
damaged. Have it repaired
immediately.
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as shown
in Fig. 4.
3. Charging
⅜
When the battery is connected to the battery charger,
charging will commence and the pilot lamp will light
on.
NOTE:
If the pilot lamp does not light, pull out the plug from
the receptacle and check if the battery is properly
mounted.
⅜
When the battery is fully charged, the pilot lamp will
go out.
NOTE:
The battery charging time becomes longer when a
temperature is low or the voltage of the power
source is too low.
When the pilot lamp does not go off even if more
than four hour has passed after start of the charging,
stop the charging and contact your HITACHI
AUTHORIZED SERVICE CENTER.
01Eng_CR10DL_US 1/7/09, 17:1911