Filter
Top Products
English
11
APPLICATIONS
⅜
Cutting metal and stainless steel pipe.
⅜
Cutting various lumber.
⅜
Cutting mild steel, aluminum and copper plate.
⅜
Cutting synthetic resins, such as phenol resin and
vinyl chloride.
REMOVAL AND INSTALLATION METHOD
OF BATTERY
⅜
How to install the battery.
Align the battery with the groove in tool handle and
slip it into place.
Always insert it all the way until it locks in place with
a little click, If not, it may accidentally fall out of the
tool, causing injury to you or someone around you
(Fig. 3).
⅜
How to remove the battery.
Withdraw battery from the tool handle while
pressing the latch (2 pcs) of the battery (Fig. 3).
ASSEMBLY AND OPERATION
Fig. 3
Latch
Handle
Battery
Pull out
Push
CHARGING METHOD
NOTE:
Before plugging into the receptacle, make sure the
following points.
⅜
The power source voltage is stated on the
nameplate.
⅜
The cord is not damaged.
WARNING:
Do not charge at voltage higher than indicated on
the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn out.
1. Connect the charger’s power cord to a receptacle.
When the power cord is connected, the charger’s
pilot lamp will blink in red. (At 1-second intervals)
Battery
Charger
Pilot lamp
Line
Fig. 4
WARNING:
Do not use the electrical cord if
damaged. Have it repaired
immediately.
2. Insert the battery into the battery charger.
<UC18YRSL>
Firmly insert the battery into the battery charger until
the line is visible, as shown in Fig. 4 .
<UC18YGSL>
Insert the battery into the battery charger as shown
in Fig. 5. Make sure it contacts the bottom of the
battery charger.
<BSL1430> <BSL1830>
Line
Insert
Fig. 5
BSL1415X
BSL1815X
01Eng_CR14DSL_US 5/25/11, 2:15 PM11