Filter
Top Products
English
12
APPLICATIONS
⅜
Drilling of brick and concrete block, etc.
⅜
Driving and removing of machine screws, wood
screws, tapping screws, etc.
⅜
Drilling of various metals
⅜
Drilling of various woods
REMOVAL AND INSTALLATION METHOD
OF BATTERY
1. Battery removal
Hold the handle tightly and push the battery latch
to remove the battery (See Fig. 3).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (See
Fig. 3).
CHARGING METHOD
NOTE:
Before plugging into the receptacle, make sure the
following points.
⅜
The power source voltage is stated on the
nameplate.
⅜
The cord is not damaged.
WARNING:
Do not charge at voltage higher than indicated on
the nameplate.
If charged at voltage higher than indicated on the
nameplate, the charger will burn up.
1. Connect the charger’s power cord to a receptacle.
When the power cord is connected, the charger’s
pilot lamp will blink in red. (At 1-second intervals)
ASSEMBLY AND OPERATION
Fig. 3
WARNING:
Do not use the electrical cord if
damaged. Have it repaired
immediately.
2. Insert the battery to the battery charger.
Firmly insert the battery into the charger as shown
in Fig. 4.
3. Charging
When the battery is connected to the battery
charger, charging will commence and the pilot
lamp will light in red. (See Table 2)
NOTE:
If the pilot lamp flikers in red, pull out the plug
from the receptacle and check if the battery is
properly mounted.
When the battery is fully charged, the pilot lamp
will blink in red slowly. (At 1-second intervals) (See
Table 2)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown
in Table 2, according to the condition of the charger
or the rechargeable battery.
Fig. 4
BSL1415
BSL1815
Handle
Pull out
Push
Insert
Latch
Battery
01Eng_DV14DSFL_US 6/8/10, 3:02 PM12