Filter
Top Products
English
27
CAUTION
ⅷ Use caution not to throw the push
lever tip onto wood when the push
lever cannot be pushed up.
METHODS OF OPERATION
CAUTION
ⅷ Squeeze the push lever when drive a
nail, otherwise the piston can not
return correctly.
ⅷ Make sure the nailing depth when the
temperature is above 104°F (40°C) or
below 32°F (0°C).
ⅷ Using the tool for an extended period
may lead to oil around the exhaust
outlet or nose, resulting in spattering.
To ensure that the material to be
nailed stays clean, wipe off any oil
that gets on the tool.
This Nailer is equipped with the push lever
and does not operate unless the push lever
is depressed (upward position).
It is intermittent operation (Trigger fire) only.
1 Position the nail outlet on the
workpiece with finger off the trigger.
2 Depress the push lever firmly until
it is completely depressed.
3 Pull and squeeze the trigger to drive
a nail.
4 Remove finger from the trigger.
To continue nailing in a separate
location, move the nailer along the
wood, repeating steps 1 - 4 as
required.
ⅷ Do not use the
electrical cord if
damaged.
Have it repaired
immediately.
ⅷ Never place your
face, hands or
feet closer than 8
inches (200 mm)
from firing head
when using.
ⅷ Do not drive nails on the top of other
nails or with Nailer at too steep of an
angle; nails can ricochet and hurt
someone.
ⅷ Do not drive nails into thin boards or
near corners and edges of workpiece.
Nails can be driven through or away
from workpiece and hit someone.
ⅷ Never drive nails from both sides of a
wall at the same time. Nails can be
driven into and through the wall and
hit a person on the opposite side.
ⅷ Never use Nailer which is defective or
operating abnormally.
ⅷ Do not use Nailer as hammer.
ⅷ Disconnect battery and fuel cell from
Nailer when:
1) it is not in use;
2) leaving work area;
3) moving it to another location; and
4) handing it to another person.
ⅷ Be careful of unwanted fastener.
If pulling the trigger more when not
driving nail at the temperature below
30°F (0°C), an wanted fastener will be
driven.
This Nailer is equipped with a FULL
SEQUENTIAL ACTUATION MECHANISM.
Explanation of FULL SEQUENTIAL
ACTUATION MECHANISM nailing operation;
First, press the push lever against the
workpiece;
next, pull the trigger to drive a nail.
NT65GS, NT65GA, NT65GB employ a
preventive mechanism for unloaded
operation.
NT65GS, NT65GA, NT65GB enter a state
where the push lever cannot be pushed up.
This takes place when the magazine is not
loaded with nails or when the remaining
number of nails becomes less than 6 or 9.
Trigger
Push lever
2
3
01Eng_NT65GS_US 12/17/08, 18:4727