Filter
Top Products
10
English
ASSEMBLY AND OPERATION
APPLICATIONS
⅜ Sanding metal surfaces.
⅜ Preliminary sanding of metal surfaces before painting, rust removal, removing old paint
before repainting.
⅜ Finishing woodwork, correcting projections of timbers from joints or assemblies.
⅜ Preliminary sanding of wood surfaces before applying paint.
⅜ Polishing or shining painted metal surfaces, such as those of automobiles, trains,
elevators, refrigerators, sewing machines, washing machines, metal appliances, etc.
⅜ Polishing varnished surfaces of wooden furniture, etc.
⅜ Shining synthetic resin or ebonite products.
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms to the power source requirements
specified on the product nameplate.
2. Power switch
Ensure that the switch is in the OFF position. If the plug is connected to a receptacle
while the switch is in the ON position, the power tool will start operating immediately
and can cause serious injury.
3. Extension cord
When the work area is far away from the power source, use an extension cord of
sufficient thickness and rated capacity. The extension cord should be kept as short as
practicable.
WARNING:
Damaged cord must be replaced or repaired.
4. Check the receptacle
If the receptacle only loosely accepts the plug, the receptacle must be repaired. Contact
a licensed electrician to make appropriate repairs.
If such a fautly receptacle is used, it may cause overheating, resulting in a serious
hazard.