Filter
Top Products
English
12
SANDING DISC ASSEMBLY AND DISASSEMBLY
WARNING: Never attempt to assemble or disassemble the sanding disc while the
disc sander is capable of being turned “ON”.
Be sure power switch is in the “OFF” position and the electrical cord
has been disconnected from the receptacle.
1. Assembling (Fig. 4)
(1) Turn the disc sander upsidedown so that
the spindle is facing upward.
(2) Attach washer nut, rubber pad and sanding
disc on the spindle, in that order.
(3) While pushing the lock lever with one hand,
lock the spindle by turning the rubber pad
slowly with the other hand.
Tighten the washer nut by using the
supplied wrench.
CAUTION:
ⅷ Tighten the washer nut securely and
confirm that the rubber pad and sanding
disc does not wobble.
ⅷ After releasing the lock lever, check to be
sure that it has returned to its normal
position.
2. Disassembling
To remove the sanding disc, follow the
above-mentioned procedure in reverse
order.
Fig. 4
6. Precaution after use
CAUTION: Do not lay the disc sander down immediately after using on a place where
there are many shavings, much dirt and dust until it has completely stopped
revolving.
If the disc sander is laid down with the sanding disc turned downward before
it has completely stopped revolving, there is a risk that the material may be
damaged and the disc sander may run wild, resulting in injury.
Wrench
Spindle
Washer nut
Rubber pad
Lock lever
Tighten
Sanding disc