Filter
Top Products
OM-925 Page 19
SECTION 6 − OPERATION
6-1. Controls
1 Wire Speed Control
Use control to select a wire feed speed. As
Voltage switch setting increases, wire
speed range also increases (see weld
setting label in welding power source or
Sections 6-2 or 6-3, as applicable).
2 Power Switch
3 Voltage Switch
The higher the selected number, the
thicker the material that can be welded
(see weld setting label in welding power
source or Sections 6-2 and 6-3, as
applicable). Do not switch under load.
. Switch must “click” into detent position
1, 2, 3, 4, or purge for proper contact.
4 Voltage Switch - “Purge” Position
In purge position, fan runs but there is no
weld output or wire feed. Use “PURGE”
setting when adjusting gas flow at the
regulator.
Ref. 217 617-A
2
3
4
PURGE1
43
2
DONOTSWITCH
WHILEWELDING
V
1
NE PAS CHANGER
DE PROCÉDÉ