Filter
Top Products
INSTALLATION INSTRUCTIONS
69-1710EFS-1
C7189U Remote Indoor Sensor
(USE WITH VISIONPRO
®
THERMOSTATS)
APPLICATION
This indoor sensor is designed to sense temperature at a remote location and send this information to the VisionPRO
Thermostat. This sensor can be used as a stand alone sensor or as part of an averaging network. Once a remote
indoor temperature sensor is connected to the thermostat, the thermostat's sensor is no longer used. The thermostat's
installer setup should be modified to tell the thermostat that remote indoor temperature sensor(s) have been used. The
Inside temperature reading on the thermostat's display will be the remote sensor(s) temperature location(s).
Fig. 1. C7189U Remote Indoor Sensor
SPECIFICATIONS
Operating Ambient Temperature Range:
45 to 88°F (7.2 to 32°C).
Display Range:
0 to 99°F (-18 to 37°C).
Sensor Accuracy:
+/-1.5°F at 70°F (+/-.84 at 21°C)
Operating Relative Humidity:
5% to 95% non-condensing.
Finish:
White.
Resistance Characteristics:
Negative temperature coefficient (NTC). Resistance
decreases as the temperature increases.
Dimensions in inches (mm):
1 1/2 (38) wide x 2 1/4 (57) high x 3/4 (19) deep.
Distance:
Maximum distance between thermostat and sensor is
200 feet.
Must be installed by a trained,
experienced technician
• Read these instructions carefully. Failure to follow
these instructions can damage the product or cause a
hazardous condition.
• Check the specification in this booklet to verify that
this product is suitable for the application.
• Always test for proper operation after installation
M24055