Filter
Top Products
Ejecting the Ring Scanner
Mounting the Arm Band
Note: The illustrations in this procedure assume the sled has not yet been
mounted to the arm band. However the sled can be mounted to the arm
band before the user puts the arm band on.
1. To eject the ring scanner, open
the connector ring with one
hand, pulling toward the outside
of the sled.
2. Push the ring scanner connector
out of the sled.
1. If the arm band straps are not fed through the buckles, feed them through
to form a loop before placing the arm band on the arm. For ease of instal-
lation, the straps should be kept looped through the buckles.
2. Place and balance the arm band assembly on the top of the desired arm
with the buckles toward the outside of the arm.
3. Using the other hand, pull each strap
end straight away from the arm until
the arm band is comfortably secured.
1
2