Filter
Top Products
25
REGULATORY REQUIREMENTS AND WARNINGS
Europe
The CE Mark is required on products with IS4110 and IS4125 Scan Engines if
the products are to be imported into European Economc Area (EEA) countries.
Use of the CE Mark requires compliance with Directives and standards
dependent upon the type of product. Information may be found at
“http://europa.eu.int/comm/enterprise/newapproach/
”.
Laser Safety
EN 60825-1:1994+A1+A2 “Safety of Laser products”.
EN 60825-1: 2007 is required after September 1, 2010..
Compliance with this standard is required for the product to bear the CE mark.
Note: Non EEA countries may impose additional testing/certification
requirements.
EMC
The IS4125 has been tested to meet Class B EMC Standards. The integrator is
responsible to maintain proper EMC techniques to maintain this performance
level.
Certain combinations of ScanQuest scan engines and associated electronics
may require certification of compliance with the European EMC Directive. EMC
compliance of finished products in Europe can be accomplished by the following
method:
• The manufacturer may certify to the EC’s Electromagnetic Compatibility
Directive 2004/108/EC. Compliance is required for the product to bear the
CE Mark.
Note: Non EEA countries may impose additional testing/certification
requirements.
Electrical Safety
The scan engines are built to conform to the European Low Voltage Directive
2006/95/EC.