Filter
Top Products
CHANGING THE BELT OR BRUSHES CLEARING A BLOCKAGE
IMPORTANT: Switch the cleaner off and
remove the plug from the electricity supply
before dismantling cleaner
IMPORTANT: Switch the cleaner off and
remove the plug from the electricity supply
before dismantling cleaner
If your cleaner is not picking up efciently, the belt or brushes (or both) may need replacing, but rst please make
sure you have:
• Emptied the dust container
• Cleaned the lters
• Checked for blockages
Turn the cleaner over and remove 5 retaining
screws attaching the brush guard to the
base.
Remove the brush guard
Remove brush assembly and check for wear
on the belt. Loop the new belt around the motor
and brush channel.
Hold the brush assembly and stretch the belt
until the brush can be slotted back into the
cleaner housing.
Rotate the brush to ensure movement of the belt.
Refit the brush guard with 5 retaining screws.
1 4
2
3
5
6
If cleaning tools were
in use check the
cleaning tool and the
removable handle.
Check the hose by
removing it from the
cleaner, stretching it to
full length .
Turn the cleaner
over and rotate the
brushes until they
are free to rotate.
Check for a blockage in
the hose socket. Use a
flexible rod to remove
any obstruction.
Removing a blockage from
the pet hair & allergen
remover.
Open the nozzle at each
side, lift cover and remove
the blockage.
*Certain models only.
- 8 -
* Certain models only.
48003559 Turbopower IM UK.indd 8 5/15/2012 9:56:29 AM