Filter
Top Products
8
English
SPECIFICATIONS
*Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
(1) Parallel Guide ........................................................... 1
(2) Template Guide ........................................................ 1
(3) Wrench ....................................................................... 1
(4) Wing Bolt (A) ........................................................... 2
(5) Lock Spring ............................................................... 2
Be sure to check standard accessories on product as it is
subject to change by areas.
Standard accessories are subject to change without
notice.
OPTIONAL ACCESORIES - sold separately
(1) Template Guide
Model M12VE M12SE
Voltage (by areas)* (110V, 120V, 220V, 230V, 240V)
Power Input* 2000 W 1700 W
Collet Chuck Capacity 12 mm or 1/2"
No-load speed 8000 – 22000 min
–1
22000 min
–1
Main Body Stroke 65 mm
Weight (without cord and
standard accessories)
5.3 kg
Bottom of Sub
base
ABC
16.5 mm 18 mm
18.5 mm 20 mm
4.5 mm
25.5 mm 27 mm
28.5 mm 30 mm
20 mm
(2) Chuck Sleeve (8 × 6)
(3) Collet Chuck (8 mm)
(4) Collet Chuck (1/4")
(5) Dust collector set (Fig. 15)
(6) Fine adjustment knob (Fig. 15)
(7) Straight guide (Fig. 16)
Optional accessories are subject to change without notice.
APPLICATIONS
⅜ Woodworking jobs centered on grooving and
chamfering.
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the
power switch is in the ON position, the power tool
will start operating immediately, which could cause
a serious accident.
3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
6
mm
8
mm
PRECAUTIONS ON USING ROUTER
1. Single-hand operation is unstable and dangerous.
Ensure that both handles are gripped firmly during
operation.
2. The bit is very hot immediately after operation.
Avoid bare hand contact with the bit for any
reason.
01Eng_M12VE_EE 7/28/09, 22:058