Filter
Top Products
3©2010 Hunter Fan Co. 43095-01 20100615
USING YOUR AUTO DUSTER
1. Take the Auto Duster out of the box and
remove the clear plastic protective bag and
place the unit on a firm level surface.
2. Before turning on the Auto Duster, you
need to confirm that the filters are firmly in
place and have not become loose during
shipping. To check the filters, open the front
grill by grabbing the tabs on each side of
the unit and unlatch them.
3. The Auto Duster
®
filter will be resting inside
the unit. If present, remove the plastic bag
surrounding the filter and place the filter
back into the Auto Duster. The filter should
be placed in the unit with the white side out
as shown in Figure 1.
4. Place the bottom of the grill back into the
indention in the base and push the door
back until the tabs on each side snap into
place.
6. Plug the unit into a 120V electrical outlet.
To turn the unit on and choose the appropriate
speed use the rotary switch on the top of the
unit.
Dust and other large particles are pulled into
the Auto Duster Grill by the fan. The plastic
screen on the filter attracts larger particles
like, pet dander and hair, and traps them.
Smaller particles such as dust are trapped
within the filter. Dust-free air is then released
into the room through the top grill. Figure 1.
HOW THE AUTO DUSTER SYSTEM
WORKS
FILTER REPLACEMENT
To replace the Auto Duster filter:
1. turn the unit off and unplug from the wall.
2. Snap the front grill off by putting your
fingers behind the tabs located on either
side of the unit and pull forward. Figure 2.
3. Remove the filter from the unit and discard.
4. Seat the new filter into the unit ensure the
white side is facing towards you.
5. Place the bottom of the grill into the
indention in the bottom of the unit and
press the grill back into place. The tabs on
either side of the unit will snap into place.
6. Plug the unit back into your wall outlet.
Figure 1.
Figure 2.