Filter
Top Products
English – 15
STARTING AND STOPPING
Before starting
K3000 Wet
Water connector
• Connect the water hose to the water supply (A).
The water is switched on and off with the water tap (B).
Starting
• Grip the front handle with the left hand.
• Grip the rear handle with your right hand.
• Press in the power switch lock with your right-hand thumb
and press in the power switch.
• Run the machine unloaded and in a safe manner for at
least 30 seconds.
Stopping
Stop the motor by releasing the power switch.
!
WARNING! Note the following before
starting:
The machine should be connected to an
earthed outlet socket.
Check that the mains voltage corresponds
with that stated on the rating plate on the
machine.
Make sure you have a secure footing and
that the cutting blade cannot touch anything.
Keep people and animals well away from the
working area.
!
WARNING! The machine (Great Britain 120V)
is not equipped with a ground fault circuit
interrupter. The machine must always be
used with an isolating transformer for
protection in case an electrical fault should
occur.
!
WARNING! The cutting blade continues to
rotate for some time after the motor has
stopped.