Filter
Top Products
14
TECHNICAL SPECIFICATIONS
Weight and Dimensions 450
Weight – dry 132 lbs 60 kg
Weight with gasoline and oil full 139 lbs 63 kg
Length 34 inch 864 mm
Width 19 inch 483 mm
Height 21 inch 533 mm
Blade
Material cut Green concrete only
Blade type 8.0” (203 mm) dry cut with tri-arbor
Blade rotation Counter clockwise, upcutting
Blade shaft speed 3350 rpm
Cutting depth 1 to 1 3/16 inch (25 to 30 mm) depending on amount of
blade wear
Cutting distance from wall 3 inch 76 mm
Average cutting rate - Estimate only. Speed will vary with job conditions and concrete mixes.
Soft aggregates 13 ft/min 4.0 m/min
Medium aggregates 9 ft/min 2.7 m/min
Hard aggregates 5 ft/min 1.5 m/min
Engine: Robin EX17
Engine oil volume 0.6 quart 0.6 liter
Gasoline tank volume 1.0 gal 3.6 liter
Type Air cooled, 4-cycle, single slant cylinder, overhead
camshaft, gasoline engine
Air lter Cyclonic type
Oil system Oil alert with auto shut down sensor
Mufer Silent type 77 dbA, exhaust deector, spark arrestor
Emissions Complies with EPA Phase 2 and CARB Tier II USA
regulations
Cooling Air cooled with internal and external cooling ns
Cylinder Aluminum with cast iron liner
Controls Engine mounted manual throttle, choke and fuel shut
off levers, manual on/off switch
CALIFORNIA AIR RESOURCES BOARD (CARB): This machine is considered a preempt Off-Road
Ap plication as relating to CARB standards. Under construction equipment, and in particular, as a Saws :
concrete, masonry, cutoff, with engine power less than 19KW (25hp), CARB standards do not apply to this
machine.
For more information see the website http://www.arb.ca.gov/msprog/offroad/preempt.htm
CONFORMITY CERTIFICATES