Husqvarna FS 6500 Welder User Manual


 
9
BEFORE YOU BEGIN: Read and understand all warnings and instructions before operating the
Machine described in this manual. WARNINGS AND CAUTIONS IN THIS MANUAL MUST BE
UNDERSTOOD AND FOLLOWED! FAILURE TO OBEY WARNINGS MAY RESULT IN
SERIOUS INJURY OR DEATH. IT IS YOUR RESPONSIBILITY to make sure persons who use
this machine have read this manual.
SAFETY WARNINGS FOR OPERATION OF THIS MACHINE
DO NOT
operate this machine unless you have read and understood this operator’s manual.
DO NOT
operate this machine without all guards in place.
DO NOT
leave this machine unattended while the engine or motor is running.
DO NOT
work on this machine while the engine or motor is running.
DO NOT
operate this machine when you are tired or fatigued.
DO NOT
operate the machine if you are uncertain of how to run the machine.
DO NOT
use damaged equipment or tool.
DO NOT
touch or try to stop a moving tool with your hand.
DO NOT
transport a machine with the tools mounted on the machine.
DO NOT
use a tool that has been dropped or damaged
DO NOT
touch the tools immediately after use. These tools require several minutes to cool after operation.
DO NOT
use damaged or worn accessory disk.
DO NOT
allow other persons to be near the machine when starting, refueling, or when the machine is in operation.
DO NOT
operate this machine in an enclosed area unless it is properly vented.
DO NOT
operate this machine in the vicinity of anything that is flammable. Sparks could cause a fire or an explosion.
DO NOT
operate this machine while under the influence of drugs or alcohol.
DO NOT
operate this machine with any of the guards removed.
DO NOT
operate this machine unless you are specifically trained to do so.
DO NOT
start operation of the machine until you have a clear work area and secure footing.
DO NOT
use flammable substances, unsecured loads or people as extra weight. Injury to the operator or other persons
could result!
DO NOT
use flammable, or improper substances to improve the material removal from the work area.
DO NOT
operate the machine if unknown substances are on or near the work area.
DO NOT
operate the machine before you determine the nature and volatility of any material that will come in contact with
the grinding tools used by this machine.
*****************
This machine was designed for certain applications only. DO NOT modify this machine or use for any
application other than for which is it was designed. If you have any questions relative to its application, DO
NOT use the machine until you have written HUSQVARNA CONSTRUCTION PRODUCTS and we have
advised you.
HUSQVARNA CONSTRUCTION PRODUCTS
17400 West 119
th
Street
Olathe, Kansas 66061, USA