Filter
Top Products
18
It is critical that the Governor and throttle on all internal
combustion engines be adjusted properly. The engine speed
is preset at the factory for the proper sawing speed. It is
NOT normally necessary to change this setting. It should be
periodically verified after the saw is placed into service. To
change the Governor setting, refer to the engine manual.
WARNING: Overspeeding the blade can result
in blade breakage and/or personal injury to the
operator and bystanders!! To assure the proper
Governor adjustment, determine the correct
blade shaft speed from the following chart.
Follow the engine manufacturer’s instruction
procedure for Governor and throttle setting.
The instructions for use and spare parts found in this document are for
information only and are not binding. As part of our product quality
improvement policy, we reserve the right to make any and all technical
modifications without prior notice.
We carry out all repairs in the shortest possible time and at
the most economical prices. (See front page for our address
and phone numbers.)
For quick supply of spare parts and to avoid any lost time, it
is essential to quote the data on the manufacturer’s plate
fixed to the machine and the part number (s) to be replaced
with every order.
Write the Model Number & Serial Number here for future
reference:
Model Number:____________________
Serial Number:____________________
The manufacturer accepts no
responsibility caused by unsuitable
use or modifications
NO LOAD BLADE SHAFT AND ENGINE R.P.M.s
BLADE SHAFT ENGINE
MODEL R.P.M. R.P.M.
5 AIR MOTOR 14"/18" 1800 2500
5E, 1PH-14"/18" 2505 3450
9R 14"/18" 2570 4000
9H 14"/18" 2610 3600
13.5R-14"/18" 2610 3600
13H-14"/18" 2610 3600
12 Governor Speed
13 Repairs
14 Service Parts