Filter
Top Products
Rear system-LED panel
The rear system-LED panel is on the SPC chassis. Complete the following steps to
replace the rear system-LED panel.
Note:
v Read “Installation guidelines” on page 31.
v Read the safety notices at “Safety information” on page 87.
v Read “Handling electrostatic discharge-sensitive devices” on page 90.
1. Shut down the BladeCenter, and remove the SPC chassis (see “Switch, power,
and cooling (SPC) chassis” on page 52).
2. Turn the SPC chassis upside-down.
3. Unplug the cable at the bottom of the midplane.
4. Unscrew the two fasteners on the LED panel.
5. Remove the LED panel from the SPC chassis.
LED panel
Cable
Note: You might need to push the LED panel cable toward the panel to
leverage the panel out of the chassis opening.
6. Install the replacement rear system LED panel by reversing the previous steps.
Note: The cable of the new rear system LED panel must be adhered to the
SPC chassis. Once the panel is positioned on the SPC chassis, the release
liner that covers the adhesive on the cable must be removed for the cable to
adhere to that chassis. The cable can then be plugged to the midplane.
Chapter 5. Service replaceable units 57