Filter
Top Products
13
English
2. Rotation + Hammering
This rotary hammer can be set to
rotation and hammering mode by
pressing the push button and turning
the change lever to
mark (Fig. 7).
(1) Mount the drill bit.
(2) Pull the trigger switch after applying the
drill bit tip to the drilling position (Fig. 8).
(3) Pushing the rotary hammer forcibly is
not necessary at all. Pushing slightly so
that drill dust comes out gradually is
just sufficient.
CAUTION:
⅜ When the drill bit touches an iron reinforcing rod, the bit will stop immediately
and the rotary hammer will react to revolve. Therefore please grip the side
handle and handle tightly as shown in Fig. 8.
3. Using the dust-collecting adaptor
and dust bag.
Using this unit with the dust-collecting
adaptor and dust bag attached creates
a more hygienic working environment
free of flying dust. Attach as shown in
Fig.1. The unit can be used as an ordi-
nary rotary hammer when the dust-col-
lecting adaptor and dust bag is not at-
tached.
(1) Attaching the dust-collecting adaptor
and the dust bag.
a) Attaching the dust-collecting adap-
tor.
Loosen the knob on the side handle
and insert the attachment rod on the
dust-collecting adaptor in the
mounting hole.
The adaptor can be inserted from
either direction A or B (see Fig.9).
In
sert and push in the hose in the
hose attachment hole of the main
unit until it reaches the inner surface
(depth 5/8" (15 mm)) and confirm
that it is firmly fixed. (see Fig.10)
Fig. 8
Fig. 7
Change lever
Push button
Fig. 9
Dust
collecting
adaptor
Hose
Mounting
holeKnob on
side handle
A
Attachment
rod
Hose
attachment
hole
Hose
Fig. 10
5/8" (15 mm)
Hose
B