Filter
Top Products
4 Form 04579652-Edition 2
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain condensate from
valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a properly sized Safety Air Fuse
upstream of hose and use an anti-whip device across any hose coupling without internal shut-off, to prevent
hose whipping if a hose fails or coupling disconnects. See drawing 16576175 and table on page 2.
Maintenance frequency is shown in circular arrow and defined as h=hours, d=days, and m=months. Items
identified as:
Note: If the action of the tool becomes sluggish:
- Pour 3 cm
3
of cleaning solution into air inlet and run tool for 30 seconds.
- Pour 3 cm
3
of Oil into air inlet and run tool for 30 seconds.
Note: Before storing the tool or leaving idle exceeding 24 hours:
- Pour 3 cm
3
of IR # 10 oil into air inlet and run tool for 5 seconds.
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled, degreased and parts
be separated by material so that they can be recycled.
The original language of this manual is English.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll-Rand Office or Distributor.
1. Air filter 6. Thread size
2. Regulator 7. Coupling
3. Lubricator 8. Safety Air Fuse
4. Emergency shut-off valve 9. Oil
5. Hose diameter 10. Oil - before starting, into air inlet