Filter
Top Products
04576856_ed6 EN-1
EN
Product Safety Information
Intended Use:
These Air Impact Wrenches are designed to remove and install threaded fasteners.
For additional information refer to Air Impact Wrench Product Safety Information Manual
Form 04580916.
Manuals can be downloaded from www.ingersollrandproducts.com.
Product Specications
Model Style
Drive
Impacts
per
min.
Recommended
Torque Range
Sound Level dB(A)
(ISO15744)
Vibration
(m/s²)
(ISO28927)
Type Size ft-lbs (Nm)
† Pressure
(L
p
)
‡ Power
(L
w
)
Level *K
2161P Pistol Square 3/4” 1025
300-1000
(407-1356)
95.0 106.0 11.5 3.8
2161XP Pistol Square 3/4” 1025
300-1000
(407-1356)
95.0 106.0 9.8 1.8
2161XP-6 Pistol
Square
extended
3/4” 1025
300-1000
(407-1356)
95.0 106.0 9.8 1.8
2171P Pistol
Square
(Pin Retainer)
1” 1025
300-1000
(407-1356)
95.0 106.0 11.5 3.8
2171XP Pistol Square 1” 1025
300-1000
(407-1356)
95.0 106.0 10.3 1.3
2171XP-6 Pistol
Square
extended
1” 1025
300-1000
(407-1356)
95.0 106.0 9.9 3.0
† K
pA
= 3dB measurement uncertainty * K = Measurement uncertainty Vibration
‡ K
wA
= 3dB measurement uncertainty
Installation and Lubrication
Size air supply line to ensure tool’s maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air lter and compressor tank daily. Install a
properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose
coupling without internal shut-o, to prevent hose whipping if a hose fails or coupling discon-
nects. See drawing 47132600 and table on page 2. Maintenance frequency is shown in a circular
arrow and dened as h=hours, d=days, and m=months of actual use. Items identied as:
1. Air lter 7. Coupling
2. Regulator 8. Safety Air Fuse
3. Lubricator 9. Oil
4. Emergency shut-o valve 10. Grease - during assembly
5. Hose diameter 11. Grease - through tting
6. Thread size
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
The original language of this manual is English.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Oce or Distributor.