Filter
Top Products
45735651_ed1 EN-1
EN
Product Safety Information
Intended Use:
These Air Orbital Sanders are designed to prepare metal and wood surfaces for painting and
nishing operations.
For additional information refer to Safety Information Manual Form 04580387.
Manuals can be downloaded from www.irtools.com.
Product Specications
Model
Free
Speed
Pad Diameter
Sound Level dB (A)
(ISO15744)
Vibration Level
(ISO8662)
rpm inch mm † Pressure (L
p
) ‡ Power (L
w
) m/s²
300G 10000 6 152 78.6 -- 4.7
† K
pA
= 3dB measurement uncertanity
‡ K
wA
= 3dB measurement uncertanity
Installation and Lubrication
Size air supply line to ensure tool’s maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air lter and compressor tank daily. Install
a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any
hose coupling without internal shut-o, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 16577215 and table on page 2. Maintenance frequency is shown in
circular arrow and dened as h=hours, d=days, and m=months. Items identied as:
1. Regulator 5. Coupling
2. Emergency shut-o valve 6. Safety Air Fuse
3. Hose diameter 7. Grease - Remove sanding pad and inject
4. Thread size
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
The original language of this manual is English.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Oce or Distributor.