Filter
Top Products
80168610_ed2 EN-1
EN
Product Safety Information
Intended Use:
These die grinders are designed for grinding, porting, polishing, de-burring, and breaking
sharp edges.
For additional information refer to Air Die Grinder Product Safety Information Manual
Form 04580288.
Manuals can be downloaded from www.ingersollrandproducts.com.
Product Specications
Model Exhaust Collet Size
Free Speed Rated Power Tool Weight Overall Length
rpm hp kW lbs Kg in mm
3101G Rear 1/4” 20000 0.33 0.25 1.3 0.58 6.8 171.0
3107G Rear 1/4” 27000 0.33 0.25 1.0 0.45 6.6 168.0
Model
Average Air
Consumption
Air Consumption
@ Load
Sound Level dB (A)
(ISO15744)
Vibration Level
(ISO8662)
cfm l/min cfm l/min † Pressure (L
p
) ‡ Power (L
w
) m/s
2
3101G 3 85 18 500 93.1 104.1 1.8
3107G 3 85 18 500 92.4 103.4 2.6
† K
pA
= 3dB measurement uncertanity
‡ K
wA
= 3dB measurement uncertanity
Installation and Lubrication
Size air supply line to ensure tool’s maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air lter and compressor tank daily. Install
a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any
hose coupling without internal shut-o, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 16573164 and table on page 2. Maintenance frequency is shown in
circular arrow and dened as h=hours, d=days, and m=months of actual use. Items identied as:
1. Air lter 6. Thread size
2. Regulator 7. Coupling
3. Lubricator 8. Safety Air Fuse
4. Emergency shut-o valve 9. Oil
5. Hose diameter 10. Grease - through tting
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
The original language of this manual is English.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Oce or Distributor.