Filter
Top Products
04580452_ed4 EN-1
EN
Product Safety Information
Intended Use:
These Drills are designed for drilling, valve guide reaming and cylinder honing operations in the
automotive industry.
For additional information refer to Air Drill Product Safety Information Manual Form 04580353.
Manuals can be downloaded from www.irtools.com.
Product Specifications
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain condensate from
valve(s) at low point(s) of piping, air filter and compressor tank daily. Install a properly sized Safety Air Fuse
upstream of hose and use an anti-whip device across any hose coupling without internal shut-off, to prevent
hose whipping if a hose fails or coupling disconnects. See drawing 16573180 and table on page 2.
Maintenance frequency is shown in circular arrow and defined as h=hours, d=days, and m=months. Items
identified as:
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled, degreased and parts
be separated by material so that they can be recycled.
The original language of this manual is English.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll-Rand Office or Distributor.
Model(s)
Handle
Type
Free
Speed
Chuck
Capacity
Sound Level dB (A)
(ISO15744)
Vibration
Level
(ISO8662)
rpm inches (mm)
Pressure (L
p
)
“K
pA
”=3dB(A)
Power (L
w
)
“K
wA
”=3dB(A)
m/s²
7802A Pistol 2000 3/8" (10) 83.0 94.0 0.2
7803A Pistol 500 1/2" (13) 83.0 94.0 0.3
7802RA Pistol 2000 3/8” (10) 83.0 94.0 0.4
7803RA Pistol 500 1/2” (13) 83.0 94.0 0.3
1. Air filter 6. Thread size
2. Regulator 7. Coupling
3. Lubricator 8. Safety Air Fuse
4. Emergency shut-off valve 9. Oil
5. Hose diameter 10. Grease - through fitting