Filter
Top Products
M10
122
3
LUBRICATION
Where Used
ARO Part # Description
Air Motor
29665 1 qt. Spindle Oil
‘‘O” Rings & Lip Seals
36460 4 oz. Stringy
Lubricant
Gears and Bearings 33153 5 lb. ‘‘EP” – NLGI
#1 Grease
Always use an air line lubricator with these tools.
We recommend the following Filter–Lubricator–
Regulator Unit:
ARO Model C28231–810
Every 8 hours of tool operation – Fill lubricator
reservoir of recommended F.R.L. with spindle oil
(29665). If an in line or air line lubricator is not used,
apply several drops of spindle oil (29665) in air inlet.
After each 160 hours of tool operation, Flush tool with
a solution of three (3) parts cleaning solvent to one (1)
part spindle oil.
Do not mark any nonmetallic surface on this tool
with customer identification codes. Such actions
could affect tool performance.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
FILTER
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
COMPRESSOR
(Dwg. TPD905–1)