Ingersoll-Rand 8506-A Power Screwdriver User Manual


 
MODEL IDENTIFICATION
MODELS WITH -EU SUFFIX ARE “EC” COMPLIANT MODELS.
NOTE: GENERAL PURPOSE WRENCH 37167 FURNISHED WITH -A AND -T MODELS.
DISASSEMBLY AND ASSEMBLY OF TOOLS
Disconnect air supply from tool or shut off air supply and exhaust
(drain) line of compressed air before performing maintenance or
service to tool.
DRIVE SECTION
Remove clutch housing from tool (left hand threads); grasp clutch
Before starting to disassemble or assemble this tool (any part or
assembly and pull from gearing.
completely), be sure to read “Inspection, Maintenance and Instal-
lation” section.
GEARING SECTION
To minimize the possibility of parts damage and for convenience
Remove drive section. Hold motor housing in a suitable fixture or
the steps for disassembly or assembly listed on the following gear.
strap wrench and remove gearing using a wrench on flats of ring
pages are recommended.
The basic sections and instructions for removing them from the
MOTOR SECTION
tool are as follows:
Motor may be removed from housing after removal of gearing.
TYPICAL CROSS SECTION OF TOOL
4