Filter
Top Products
AIR AND LUBE REQUIREMENTS
FOR LUBRICATION OF
GEARING ASSEMBLY
FOR LUBRICATION OF
GEARING ASSEMBLY
LUBRICATION POINTS
(GREASE FITTING LOCATIONS)
Air pressure of 90 p.s.i.g. (6.2 bars) at the air inlet of the tool is re-
quired for maximum motor efficiency. An air regulator should be’
installed to maintain this pressure when the tool is in operation.
ARO will not guarantee directional response when the pressure
drops below 60 pounds (operating) at the air inlet of the tool, or an
oiler/filter is not used.
Filtered and oiled air will allow the tool to operate more efficiently
and yield a longer life to operating parts and mechanisms. A line
filter capable of filtering particles larger than 50 microns should be
used with a line oiler.
A Filter/Regulator/Lubricator (F.R.L.) assembly is recommended
for use with this air tool. The capacity of the individual Filter-Regu-
lator-Lubricator is adequate to provide clean (40 micron), oiled
and regulated air for the tool. See page 18 for recommended F-
R-L systems.
RECOMMENDED HOSE SIZE: See page 18 for recommended
power air inlet systems.
- FOR LUBRICATION OF
LEAD SCREW AND LEAD
SCREW NUT
NOTE: MUST ALWAYS BE 1/2
TO 2/3 FULL OF GREASE
Inject grease (40036-1) - 2 to 3 strokes - thru all grease fittings
after each 40 hours of operation, or as experience indicates. Cav-
ity of housing (45443) and cavity of adjusting nut (45444) should
be kept 1/2 to 2/3 full of grease (40036-1). When assembling lead
screw and lead nut to tool, lubricate internal threads of lead nut
and threads on lead screw liberally with grease (40036-1) and fill
cavities of housing and adjusting nut from 1/2 to 2/3 full.
RECOMMENDED LUBRICANTS:
MOTOR: Spindle oil 29665, 1 qt. (.9 liter) or equivalent type 1 light
oil. Consult manufacturer of air line lubricator used to insure
equivalent oil used is compatible with construction of lubrica-
tor bowl.
LEAD SCREW, GEARS, BEARINGS, ETC.: Grease 400361,1
lb. (.45 kg) container, or equivalent grade containing molyb-
denum disulfides.
“0” RING: Lubricant 36460, 4 oz. (113 g) tube.
PART NUMBER WHERE USED
29665
AIR MOTOR
DESCRIPTION
A HIGH QUALITY LIGHT TURBINE OR SPINDLE OIL, RUST INHIBITED, WITH A VISCOSITY OF 100-150 S.U.S. AT
100” F. OIL IS COMPATIBLE WITH POLYCARBONATE TYPE AIR LINE LUBRICATOR BOWLS.
40036-1 GEARS & BEARINGS
A HlGH QUALlTY “EP” EXTREME PRESSURE MOLYBDENUM GREASE SUlTABLE FOR CLUTCH APPLICATIONS,
NLGI NO. 1, FREE OF CORROSIVE MATTER AND FILLERS, WITH A VISCOSITY OF 500-700 S.U.S. AT 100” F.
36460 “0” RINGS & LIP SEALS
A STRINGY LUBRICANT FOR RUBBER SEALS, WITH GOOD ADHESIVE QUALITIES.
6