Filter
Top Products
IRN37 - 160K - CC & IRN50 - 200H & IRN75 - 160K - 2S & IRN - 100 - 200H - 2S & IRN 250 - 300H - 2S
http://air.irco.com
7
When using compressed air always use appropriate
personal protective equipment.
All pressure containing parts, especially flexible hoses
and their couplings, must be regularly inspected, be free
from defects and be replaced according to the Manual
instructions.
Compressed air can be dangerous if incorrectlyhandled.
Before doing any work on the unit, ensure that all
pressure is vented from the system and that the machine
cannot be started accidentally.
Avoid bodily contact with compressed air.
The safety valve located in the separator tank must be
checked periodically for correct operation.
Whenever pressure is released through the pressure relief
valve, it is due to excessive pressure in the system. The
cause for the excessive pressure should be investigated
immediately.
Materials
The following substances are used in the manufacture
of this machine and may be hazardous to health if used
incorrectly:
preservative grease
rust preventative
compressor coolant
WARNING
AVOID INGESTION, SKIN CONTACT AND
INHALATION OF FUMES
For further information, request and consult the coolant
Material Data Sheet (UK ACGP 011/96 −ULTRA COOLANT
ACGP 029/90−food grade coolant. For USA served areas,
use MSDS sheet APDD 236) from your local IR office,
Distributor or Air Center.
Should compressor lubricant come into contact with the
eyes, then irrigate with water for at least 5 minutes.
Should compressor lubricant come into contact with the
skin, then wash off immediately.
Consult a physician if large amounts of compressor
lubricant are ingested.
Consult a physician if compressor lubricant is inhaled.
Never give fluids or induce vomiting if the patient is
unconscious or having convulsions.
•
•
•
The above information contains data supplied in support
of United Kingdom Control of Substances Hazardous to
Health (C.O.S.H.H.) regulations
Transport
When loading or transporting machines ensure that the
specified lifting and tie down points are used.
It is recommended that the machine be moved using the
fork lift slots in the machine base.
Refer to section 8-General Information for reference
information.
Electrical
The compressor has high and dangerous voltage in the
motor starter and control box. All installations must be
in accordance with recognized electrical codes. Before
working on the electrical system, be sure to remove
voltage from the system by using a manual disconnect
switch. A circuit breaker or fuse safety switch must be
provided in the electrical supply line leading to the
compressor.
Those responsible for installation of this equipment
must provide suitable grounds, maintenance clearance
and lightning arrestors for all electrical components in
accordance with National and Local code requirements.
Keep all parts of the body and any hand−held tools or
other conductive objects, away from exposed live parts
of the compressor electrical system. Maintain dry footing,
stand on insulating surfaces and do not contact any other
portion of the compressor when making adjustments or
repairs to exposed live parts of the compressor electrical
system.
Close and lock all access doors when the compressor is
left unattended.
Do not use extinguishers intended for Class A or Class B
fires on electrical fires. Use only extinguishers suitable for
class BC or class ABC fires.
Attempt repairs only in clean, dry, well lighted and
ventilated areas.
Connect the compressor only to electrical systems that
are compatible with its electrical characteristics and that
are within it’s rated capacity.
5.0 SAFETY