Filter
Top Products
28
29
Restore Factory Defaults
If you are having difculty nding or connecting to your print server using the Control Center software due
to network issues or a forgotten password, you can clear all settings on the server using the Init button on
the device. To properly reset all settings to factory defaults, unplug the power adapter from the device.
Then hold the Init button and plug the power adapter back in. Instead of blinking alternately as during
a normal startup, the USB1 and USB2 lights should begin blinking at the same time. Unplug the power
adapter once again, and then plug in the adapter without holding the Init button. The server should go
through the normal startup process and all network and password settings will be at defaults.