Filter
Top Products
10
6. Install the housing (A, Fig. 5) to two support
legs (B, Fig. 5) using four M8 x 16 hex cap bolts,
eight M8 flat washers, and four M8 hex nuts (C,
Fig. 5). Be sure hose opening faces fan housing.
Note: For filter bag models only – Before attaching
third support bracket place the hanger bracket (D,
Fig.5) between the support bracket and the
housing. This action is not necessary for canister
filter units.
7. Tighten all nuts and bolts at this time with a 13mm
wrench.
Hose
Referring to Figure 6:
8. Attach the hose (B) between the collector housing
(A) and the impeller housing (D) with two clamps
(C). Tighten the clamps to secure the hose.
This completes the Base Unit assembly. If you
purchased the DC-1100BK or DC-1100MK Dust
Collector (filter bag versions), continue on the
following page. If you purchased the DC-1100CK Dust
Collector (canister filter version), proceed to Canister
Kit Assembly section on page 12.
Figure 5
Figure 6