WARNING
• Read and understand the entire instruction manual before attempting assembly or operation.
• All JET bandsaws are designed and intended for use by properly trained and experienced
personnel only. If you are not familiar with the proper and safe operation of a bandsaw, do
not use until proper training and knowledge have been obtained.
• Always wear approved safety glasses/face shields while using this machine.
• Make certain the machine is properly grounded.
• Before operating the machine, remove tie, rings, watches, other jewelry, and roll up sleeves above
the elbows. Remove all loose clothing and confine long hair. Do NOT wear gloves.
• Keep the floor around the machine clean and free of scrap material, oil and grease.
• Keep machine guards in place at all times when the machine is in use. If removed for maintenance
purposes, use extreme caution and replace the guards immediately.
• Do NOT over reach. Maintain a balanced stance at all times so that you do not fall or lean against
blades or other moving parts.
• Make all machine adjustments or maintenance with the machine unplugged from the power source.
• Use the right tool. Don't force a tool or attachment to do a job which it was not designed for.
• Replace warning labels if they become obscured or removed.
• Make certain the motor switch is in the OFF position before connecting the machine to the power
supply.
• Give your work undivided attention. Looking around, carrying on a conversation, and "horse-play"
are careless acts that can result in serious injury.
• Keep visitors a safe distance from the work area.
• Use recommended accessories; improper accessories may be hazardous.
• Make a habit of checking to see that keys and adjusting wrenches are removed before turning on the
machine.
• Always keep hands and fingers away from the blade when the machine is running.
• Never hand hold the material. Always use the vise and clamp it securely.
• Keep belt guard, blade guards, and wheel covers in place and in working order.
• Always provide adequate support for long and heavy material.
• Use a sharp blade and keep machine clean for best and safest performance.
• Failure to comply with all of these warnings may cause serious injury.