Filter
Top Products
6
close as possible to the work piece.
9. Always wear protective eye wear when
operating, servicing or adjusting machinery. Eyewear
shall be impact resistant, protective safety glasses with
side shields complying with ANSI Z87.1 specifications.
Use of eye wear which does not comply with ANSI
Z87.1 specifications could result in severe injury from
breakage of eye protection. See figure B.
10. Non-slip footwear and safety shoes are
recommended. See figure C.
11. Wear ear protectors (plugs or muffs) during
extended periods of operation. See figure D.
12. The workpiece, or part being sawed, must be
securely clamped before the saw blade enters it.
13. Remove cut off pieces carefully, keeping
hands away from sawblade.
14. Saw must be stopped and electrical supply
cut off or machine unplugged before reaching into
cutting area.
15. Avoid contact with coolant, especially
guarding your eyes.
A
B
C
D
1. Always wear leather gloves when handling
saw blade. The operator shall not wear gloves when
operating the machine.
2. All doors shall be closed, all panels replaced,
and all other safety guards in place prior to the machine
being started or operated.
3. Be sure that the blade is not in contact with the
workpiece when the motor is started. The motor shall
be started and you should allow the saw to come to full
speed before bringing the workpiece into the saw blade.
4. Keep hands away from the blade area. See
figure A.
5. Remove any cut off piece carefully while
keeping your hands free of the blade area.
6. Saw must be stopped and electrical supply
must be cut off before any blade replacement or
adjustment of blade support mechanism is done, or
before any attempt is made to change the drive belts or
before any periodic service or maintenance is per-
formed on the saw.
7. Remove all loose items and any unnecessary
work pieces from the area before starting machine.
8. Bring adjustable saw guides and guards as
240 volt lines 120 volt lines
0-50 feet No. 14 No. 14
50-100 feet No. 14 No. 12
Over 100 feet No. 12 No. 8
Conductor length
AWG (American wire gauge) number
General Electrical Cautions
This saw should be grounded in accordance with
the National Electrical Code and local codes and
ordinances. This work should be done by a qualified
electrician. The saw should be grounded to protect the
user from electrical shock.
Wire sizes
Caution: for circuits which are far away from the
electrical service box, the wire size must be increased
in order to deliver ample voltage to the motor. To
minimize power losses and to prevent motor overheat-
ing and burnout, the use of wire sizes for branch
circuits or electrical extension cords according to the
following table is recommended:
Safety instructions on sawing systems
20.Some dust created by power sanding, sawing,
grinding, drilling and other construction activities
contains chemicals known to cause cancer, birth
defects or other reproductive harm. Some examples of
these chemicals are:
Lead from lead based paint
crystalline silica from bricks and cement and other
masonry products, and
arsenic and chromium from chemically-treated
lumber.
21.Your risk from those exposures varies, depend-
ing on how often you do this type of work. To reduce your
exposure to these chemicals: work in a well ventilated
area, and work with approved safety equipment, such as
those dust masks that are specifically designed to filter
out microscopic particles.